Search results for 'Alpha 200 Corn Skimmer'

  1. 2009/05/08 -- Some comments of Vertex Alpha 200 Corn Skimmer

Some comments of Vertex Alpha 200 Corn Skimmer

2009/05/08 13:36
Leave a Comment


1. Ozone을 위한 구멍은 막으나 안막으나 스키밍과는 거의 관계가 없다.
It is a very low difference , for waterinjekt, so the Ozonbypass was not connected with a Ozonmaker.
Max. 50-70 L/h. The Airintake is all the same, open or closed, or without the Red Ozontube..
Customer can using all three ways. No difference by Skimmate in the Cup.

2. 스키머는 수심 9~10인치정도에 두는 것이 더 효율적이다 이때 wedgepipe는 거의 다 open한다 11인치 이상에서는 오히려 LPH가 떨어진다
In speaking with Scott (sjm817) about the skimmer some today I think we have come to the conclusion that this skimmer runs better the deeper it is. I am now at 10" with this skimmer, and no ozone tube hooked up and am pulling more, approximately 2000LPH - 2100LPH, plus the wedge pipe is being able to be ran in a much more "open" position. If some of you guys want to try this please report back
as to what you find out.
2. Vertex 200의 경우 10인치로 했을때 Red nozzle로 연결을 하면 스키머컵으로 거품이 넘쳐 흘러버립니다. 또한 출수파이프와 에어호스사이에서 물이 새어 나오는 현상이 발생하는데 이것은 물의 수위가 너무 높기 때문이라고 합니다. 따라서 9~9.5인치정도로 수위를 맞추고 Red Nozzle을 연결하는 것이 좋다고 합니다.

7th - If you have water coming out of that hole in 10" of water, then you are running your water level too high. I would recommend using the red nozzle, in 9.5" of water to start an Alpha 200, and then back it down to 9" if you are still overflowing at that point.


3. 노즐 교체

Changing the nozzles is very easy to do. Pull the venturi off, and push the back of the red nozzle out of the front, it will come right out. Then put the new size in. It takes about 10 seconds to do. HTH!









Source from RC
http://www.reefcentral.com/forums/showt ··· ber%3D12

"My Equipment" 카테고리의 다른 글

spsholic My Tank/My Equipment ,

2009/05/08 13:36 2009/05/08 13:36